Push down on the blue quick-disconnect Electrical Shock Hazard locking ring, and pull the door water tube. In addition, ensure that the freezer is kept at the proper temperature. If the water supply tube is frozen, thaw it out. . First disconnect power to the unit.
This time depends on several factors times the door is open, amount of food stored, ambient temperature. Noises from the appliance are normal, since the fans and compressors for controlling its operation switch on and off automatically. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. As an aside, the manual states that although it is recommended, the filter is not necessary for the system to operate but considering the difference it makes in the taste of our water and ice, i wouldn't even think of not using one! Disconnect the lines from the water valve in back, drain the lines, connect them again, manually cycle the ice maker hold switch down 15 seconds? Once removed, you should see the water reservoir that may just be a big roll of line or it may be a plastic container. Use a towel to dry the seal and the surrounding areas, and close the freezer. If this does not solve the issue, consult with a professional, as you may have a defective part, such as a condenser, thermostat sensor or fan motor.
Place all the food back in the freezer and plug it back in. The first is the water lines attached to an automatic ice maker or water dispenser, if you model has either of those options. To access the coils, look for the grill and remove it by popping out the snaps which hold it in place or unscrewing it where applicable. Kinked Line The water line consists of small plastic or copper tubing that connects a small valve on the wall to the refrigerator. While plastic tubing does not crimp, if the tubing gets hung up under the refrigerator or is bent at a 90-degree angle, water does not flow to the dispenser. When the refrigerator is running there is a fan in the top of the freezer that circulates air through the freezer as well as in the refrigerator.
Then check for continuity across the valve coils. Check the water supply line When checking the water supply line, ensure the water supply is properly connected to a cold water supply and the water shutoff valve is fully opened. This ice bridge will cause the harvest fingers to jam. The system still failed to operate without the filter in place. I reconnected the water line and reinstalled the filter which I had emptied , and upon trying the water dispenser again I could hear water flowing into the filter - and then stopping.
This happens when food particles or other debris clogs up the drain hose, which can lead to ice buildup and, eventually, water leaking out of the freezer and refrigerator. Any unauthorized review, use, disclosure, distribution, or copying is prohibited. If power is not present, then you will need to check the dispenser for a faulty switch or actuator. Note: Reaching the preset temperatures requires a variable amount of time. Remove the control panel cover and verify that the actuator contacts the dispenser switch properly and if not, check the actuator housing bracket, switch mounting bracket and the actuator pivot.
Open the fresh food section and remove the vegetable bin. Please read our and for more information about the review process. With this connection loose, when you take the water fitting loose, inside the dispenser, you will now be able to pull the water tube up through the door. Thanks the post was very helpful. Fix: First, cut power to the refrigerator. Most manufacturers recommend replacing the filter every 6 months but local water conditions may require that you replace more frequently.
Partially open the freezer door and lift it not fall in the next step. Located at the bottom of the unit, typically behind a grill, it is placed near the heat-generating condenser and compressor. Electrical Shock Hazard Disconnect power before servicing. Result: The red status light should be steady on. Some models have a redesigned water line to help stop this type of problem. Again, I had changed the filter about two month previously, so routine maintenance wasn't suspect - but I removed it and emptied it out you be amazed at the black particles that come out, after only a month or 2! Your review will be posted on Consumer Reports for other subscribers to view.
Does everything freezing in the bottom of the frig. When you shop through retailer links on our site, we may earn an affiliate commission — 100% of the fees we collect are used to support our mission. If you are unable to fix your refrigerator with the information above, enter your model number into the search box for additional repair help. Does this model have a water filter? To repair this, reconnect the coupling and open the door. The refrigerator is easily one of the most important appliances in your home.
At the bottom of the freezer door there should be a coupling, disconnect the coupling. If you feel you have received this message in error, please view our customer care or access your here. There must be at least 1 and it could have 2 numbers in the first part of the model number. Verify that you have adequate pressure at the inlet to the valve, that the inlet screen is not plugged and that there are no restrictions in the inlet or outlet tubing. We have provided many important safety messages in this Job Aid and on the appliance. Airflow for the fresh food section will enter at the top and exit at the bottom. These drains can become clogged with food debris or ice.